35' Carver 350 Mariner 2001

Step into the single level salon through the wide sliding glass doors from the cockpit, and you can immediately see why the 350 Mariner is so popular. A dinette that converts to sleep 2 is located immediately to port. Opposite the dinette is an ultra-leather pull out sofa with built in entertainment center. The full galley is located forward of the dinette, and features tons of counterspace and a full sized refrigerator. The oversized head with separate stall shower, and master stateroom are located forward.

The flybridge on the 350 Mariner is exceptionally spacious, and seat 10 comfortably on a triple wide bench seat, and a portside lounge. There is a built in wet bar with ice maker, and a table. Wide walk arounds and molded stairs from both sides of the cockpit allow easy access all around the yacht. The Bow features a built in seat that converts to a sun lounge- A sun lover's paradise!

Bow Sunlounge

Fenders and Docklines

Bow Seat Cover

Hot & Cold Transom Shower

Full Exterior canvas (black)

Maxwell Windlass

Anchor and Chain

AC/DC distribution panels with magnetic circuit breakers and integral bilge blower controls; AC voltmeter; AC ammeter. Batteries (2) - deep cycle, marine (12V). Battery charger - electronic, AC-DC converter. External connectors - CATV, telephone. Ground Fault Circuit Interrupt (GFCI) protection - all 110V outlets. Shore power connector - 30 amp. Shore power cord - 50 ft. Wiring system - stranded, tinned copper, harnessed, color-coded, labeled, meets or exceeds ABYC standards.

The 350 Mariner features a full galley with spacious counter tops, a full sized Norcold refigerator/freezer, built in coffee maker, 2 burner stove, carousel microwave, and stainless steel sink. Enjoy a waterfront dinner tonight!

Mercruiser 350 MAG MPI engines (2). Dripless shaft logs. Exhaust mufflers - engines. Fuel tanks - welded, baffled 5052 aluminum. Hydraulic steering. Propellers. Propeller shafts - aquamet. Rudders - 421 manganese bronze. Seawater cooling - engines. Cutlass bearings - synthetic rubber composite. Struts - 421 manganese bronze. Trim tabs - stainless steel, hydraulic.

Starboard engine was replaced - dealer installation, in 2010 - 620 hrs, Port engine has 936 hrs. All belts ,hoses and alternators have been replace in the last 6 months. Recent compression test on both engines rated excellent.

This Carver Mariner 350 has been professional maintained. The seller is very motivated.